LP SmartSide installation in Marietta, GA, Smyrna, GA & Nearby Cities

By Siding Ninja | 08/23/2025

LP SmartSide Installation: Key Things to Know

LP SmartSide is a popular engineered wood siding known for its durability, impact resistance, and attractive appearance. Proper installation is critical to ensure long-term performance and maintain warranty coverage. Siding Ninja offers LP SmartSide installation in Kennesaw, GA, Marietta, GA, Powder Springs, GA, Smyrna, GA, Woodstock, GA and surrounding areas.

These are the most important things to know:LP SmartSide installation in Kennesaw, GA, Marietta, GA, Powder Springs, GA, Smyrna, GA, Woodstock, GA

  1. Proper Storage and Handling:

Store siding panels flat and off the ground on a dry surface. Protect them from moisture by keeping them covered until ready to install. Avoid exposing the product to water before it’s painted or sealed.

  1. Acclimation:

Let the siding acclimate to local environmental conditions for at least 24 hours before installation. This minimizes expansion or contraction after it’s installed.

  1. Use the Right Fasteners:

Use corrosion-resistant nails or screws, preferably hot-dipped galvanized or stainless steel. Fasteners should be long enough to penetrate the framing by at least 1½ inches.

  1. Nailing Guidelines:

Fasten panels every 6 inches on center along the edges and 12 inches in the field for panels. Maintain recommended edge and end distances (typically ¾” from edges, 3/8″ from ends).

  1. Flashing and Sealing:

Install metal flashing above all horizontal trim, windows, and doors. Caulk all joints and gaps with high-quality, paintable exterior sealant.

  1. Joint Treatment:

For lap siding, use butt joints over studs and install with joint flashing or sealant. LP recommends factory-primed ends for best results.

  1. Maintain Clearances:

Maintain a minimum of 6 inches from the ground and 1 inch above roofs, decks, and other horizontal surfaces to prevent moisture wicking.

  1. Painting and Finishing:

Paint within 180 days of installation using high-quality acrylic latex paint. All cut ends must be primed or sealed before painting.

  1. Follow Manufacturer Guidelines:

Always follow LP’s installation manual for your specific product line (lap, panel, or trim) to ensure proper installation and warranty compliance.

Call us anytime if you need more information.

Posted in Blog, Siding